Valve professional knowledge: common faults and elimination methods of pressure relief valves

October 16 [Wed], 2013, 16:49
First, the device crack can't be back to the actual seat after the valve discharge,This is due to the following factors. A planting season makes the control device stem bended. Your China ball valves fracture is not appropriately installed or even it is trapped. So the valve should be put together again. Subsequent, leakage: Within the normal operating pressure of apparatus, there is loss beyond the making it possible for level involving valve crack and control device seat.The reason why are because followings. There is certainly dirties between the device crack as well as valve closing surface. The issue can be fixed by opening the device several times with the use of a wrench. Hence dirties can be in a rush away. There exists damage of closing surface. It really is suggest using grind or perhaps grinding following turning to repair the valve. The device stem is actually bended, tilt or lever and also pivot are deflected, making the valve primary and device disc displacement. The perfect solution is is to build or switch the valve. The actual spring provides decreased firmness or completely loses flexibility. The solution is replacing a new spring and also regulating the beginning pressure again.
Third, the control device can available when the essential pressure may be reached,The real reason for this solution to happen is that the pressure just isn't fixed. How much compression of spring or even the position involving hammer ought to be regulated once again. The valve crack and also valve seat are adhere. It is necessary to do guide book release as well as dewatering test associated with safety valve regularly. For that lever type safety valve, it is easy to the lever to be stuck or the hammer to get moved. The perfect solution is to get a grip on the position involving hammer, and to make sure the handle moving openly. Fourth, pressure is up soon after exhaust This is caused by the making capacity associated with selected valves are generally smaller than the protection relief actions of equipment. It's required to decide on a appropriate safety valve. An unacceptable position associated with valve base centerline or the rusted spring makes the valve crack not necessarily open to a particular height. The perfect solution is for the particular stem reassblemy once more or changing a early spring. It should to consider a tire out pipe which can be according to the match the rules associated with safety section of the exhaust emissions if the wear out pipe segment is not sufficient.
Fifth, the valve crack jumps frequency or vibrating.This really is caused by the particular too big seriousness of spring. Thus a springtime with correct severity needs to be replaced. If the adjustment diamond ring is not appropriately adjusted, which make the pressure rear seat with too much strain. It is suggested to regulate the adjusting ring once more. If the launch pipe weight is too big, which result in excessive pollution levels of again pressure, it's suggest decreasing discharge pipe resistance. Six, China ball valves starting when the force is attained to the need, The main reason is the constant force is not correct, and the planting season is previous, so the flexible force reduced. The solution would be to tighten the particular regulating nails or exchanging a planting season.
プロフィール
  • プロフィール画像
  • アイコン画像 ニックネーム:valvess2013
読者になる
2013年10月
« 前の月  |  次の月 »
1 2 3 4 5
6 7 8 9 10 11 12
13 14 15 16 17 18 19
20 21 22 23 24 25 26
27 28 29 30 31
最新コメント
ヤプミー!一覧
読者になる
P R
カテゴリアーカイブ
月別アーカイブ
http://yaplog.jp/valvess2013/index1_0.rdf